Skip to main content

A-100LC6 Vintage Low Cost Frame

  • Model :
    A-100LC6V
  • Price :
    540 €
  • Technical details :

    Dimensions: 445 mm x 275 mm x 160 mm

A-100LC6 Vintage Low Cost Frame

Affordable version of the A-100 suitcase for mounting Eurorack

    • 6 U (2 x 3U)
    • useable width: 84 HP
    • contains: 1 power supply A-100PSU3, 2 bus boards
  • Measures:
    outside: approx. 445 x 275 x 160 mm
    inside: 2 x 84 HP x 3 U (two bus boards), useable depth for A-100 modules: approx. 80 mm in the power supply area (bottom right), resp. approx. 110 mm in the remaining area (measured from inner side of the front panel until end of the pc board of the module)

    Quantity of bus boards: 2

    Weight (without modules): about 4 kg

    Maximum Output Current:
    with built-in  A-100PSU2 (until about end of 2015): +12V/1200mA, -12V/1200mA
    with built-in A-100PSU3 (since about early 2016): +12V/2000 mA, -12V/1200mA, +5V/4000mA

    In the area near the power supply (bottom right) no modules should be assembled that are sensitive against transformer hum. We recommend to assemble only control voltage modules in this area (e.g. LFO, ADSR, trigger delay, clock divider/sequencer, sequencer, slew limiter, MIDI interfaces and so on) but no audio modules (VCO, VCF, VCA, VCP, frequency shifter, ring modulator, spring reverb and so on). Even modules width increased depth (e.g. A-113 or A-126) cannot be assembled in the power supply area. They have to be placed in a position outside the power supply area (e.g. in the upper row). But this applies only for a few modules. Normally it is no problem to arrange all modules by mounting modules with smaller depth in the power supply area.


Where to buy